Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterFast, Reliable Chimney Repair Across Redan
Chimney repair in Redan, GA typically runs between $185 and $2,800 depending on what’s actually wrong. A cracked crown or rusted cap might fall at the low end of that range; a flue relining or partial rebuild lands higher. We give every Redan homeowner a written price before any tool comes off the truck, so the number you approve is the number you pay. Flint Chimney Sweep has covered Redan’s mix of 1960s brick ranches and 1980s two-story subdivisions since 2002, and our crews know exactly which failure modes show up on which side of Redan Park. If your chimney is leaking, spalling, or pulling smoke back into the house, call (830) 251-4560 and we’ll get a uniformed, background-checked technician to your door with a camera and a written quote.
Why Flint Chimney Sweep Is Redan’s Preferred Chimney Repair Company
Redan homeowners tend to be direct: they want the work scoped, priced, and guaranteed before anyone climbs a ladder. That’s how we’ve always operated. Hank Delano set the standard for our crews long before The Garrison Standard had a name, and every repair we do in Redan carries a 365-Day Done Right Promise in writing. If a covered repair fails within one full year, we return and make it right at no charge. No argument, no second invoice, no fine print.
Our techs know Redan’s housing stock because they’ve been driving it for years. They can tell you within five minutes whether a chimney on Pineland Drive needs a crown repair or whether that dark staining means water has already gotten behind the brick on S Stone Mountain Lithonia Road. A live person answers our phone 24/7, so when you call about a leaking chimney at 9 p.m. after a hard rain, you’re talking to us, not a voicemail tree.
Every Chimney Repair job in Redan starts with a camera inspection. You see the photos. You get the written quote. You decide what gets fixed, and nothing gets recommended unless the camera proves it’s there.
Chimney Masonry Repair in Redan
Chimney Masonry Repair in Redan is the service we recommend most often on the older side of Redan Park, where original 1960s and 70s brick stacks are now 50 to 60 years old. The mortar joints wear down, water gets in, the brick face starts spalling (flaking and popping off in pieces), and what began as a cosmetic issue becomes a structural one. In Redan’s humid Georgia climate, the freeze-thaw cycle isn’t the main culprit the way it is up north. Here it’s more often slow, year-round moisture absorption that softens the mortar and loosens individual bricks.
Mortar Repointing and Tuckpointing
Repointing is the trade term for cutting out failing mortar joints and replacing them with fresh mortar that matches the original color and profile. On a Redan brick ranch with a single flue chimney, a partial repoint typically runs $400 to $1,200 depending on how many courses of brick are involved. Tuckpointing, which adds a narrow line of contrasting mortar for a crisp visual profile, runs on the higher end because it’s slower, detail work. We use the same mortar type that matches your existing brick, so a repair on a 1972 chimney doesn’t look like a patch.
Spalling Brick Repair and Rebuilding
Once brick faces are spalling, you can’t glue them back. The damaged bricks get removed one at a time and replaced with matching units. When the damage runs deep into the stack or the chimney is leaning noticeably, we quote a partial or full rebuild. Partial rebuilds in Redan start around $1,800 and go up from there, because they involve shoring the stack, cutting out the bad brick, and relaying courses while keeping the flue liner intact. We’ll tell you straight when a rebuild can wait one more season, and we’ll put that in writing too.
Chimney Cap Installation in Redan
Chimney Cap Installation in Redan is the single best dollar-for-dollar repair for older masonry chimneys that have an open flue or a cracked, poorly fitted cap. A missing or failed cap lets Redan’s heavy spring and summer rain run straight down the flue, where it hits the smoke shelf, rusts the damper, and slowly destroys the mortar from the inside. Homeowners often discover this as water spots on the ceiling near the fireplace or a musty smell that gets worse after a storm.
Stainless Steel and Copper Caps
For most Redan homes we install stainless steel caps from Gelco or Copperfield, which carry a longer service life than the cheap galvanized caps that rust through in a few years. A standard stainless cap install runs $285 to $650 including the cap, the fasteners, and sealing the flue tile. Copper caps cost more, $700 to $1,100, and are chosen more for looks on high-visibility chimneys along Five Forks Trickum Road. We also install Chase Covers and specialty caps for the factory-built fireplaces common in Redan’s 1980s and 90s subdivisions, which require manufacturer-specific sizing and can’t be covered with a generic one-size cap.
Dampers and Chase Covers
When the cap failed on a Redan chimney, the damper below it usually took water damage too. We repair or replace top-sealing dampers from Olympia Chimney, which mount at the top of the flue and seal far better than a worn throat damper. If the chase cover on your factory-built fireplace is rusted through, we order the correct replacement for the unit. We don’t patch chase covers with roofing tar. The seal either works or water keeps coming back.
Trusted Brands We Service in Redan
Flint Chimney Sweep works with professional-grade materials, selected for the specific job on your roof, not for our margin. On Redan chimneys you’ll typically see us install or repair components from Gelco, Olympia Chimney, and Copperfield. These are the brands that meet the original manufacturer specs for the factory-built fireplaces we service throughout the Redan, Stone Mountain, and Snellville corridors. We also carry DuraFlex liners for flue relining jobs where a clay tile liner has cracked or separated. The brand name goes on your written quote, so you can verify exactly what you’re paying for. Our Redan customers rarely wait more than a few days for parts.
Common Chimney Repair Problems We See in Redan Homes
- Water intrusion through failed caps and cracked crowns. On Redan’s older brick stacks, a cracked crown lets water sit on top of the masonry and wick down into the mortar joints. The first sign is usually white efflorescence on the brick or a damp smell from the fireplace after a hard rain.
- Rusted-out chase covers on factory-built units. Redan’s 1980s and 90s subdivisions are full of wood-framed chimney chases with metal covers that eventually rust through. Water drops straight onto the flue liner, corrodes the joints, and sends rust streaks down the siding.
- Spalling brick on south-facing chimneys. The south side of a Redan chimney catches full Georgia sun all day, which accelerates moisture evaporation and leaves salt deposits that push the brick face off. Homes near Redan Park with mature trees blocking airflow tend to show this on the shaded sides too, because the moisture never fully dries.
- Glazed creosote from infrequent burning. Redan homeowners who burn only a few fires a year can still build up second-degree creosote, especially if they burn unseasoned wood or never have the flue inspected. What starts as a cheap Level 1 inspection becomes a flue liner repair when the glazed coating isn’t caught in time.
Pricing for Chimney Repair in Redan, GA
Here are the ranges our Redan customers actually see on their written quotes. A standard chimney cap replacement runs $285 to $650 for stainless, $700 to $1,100 for copper. Mortar repointing on a typical single-flue brick stack runs $400 to $1,200. A crown repair, which means removing the cracked top layer and re-casting it, runs $350 to $800. Partial chimney rebuilds start near $1,800 and climb based on the height of the stack, the condition of the flue liner, and access from your roof. A Level 2 camera inspection with a written photo report runs $149 when paired with a sweep; a sweep alone in Redan runs $189 to $289 depending on the flue type and the amount of creosote. The estimate itself is free. You don’t pay to look. Call (830) 251-4560 and we’ll give you the written number before booking, not after we’re on your roof.
We Also Serve Cities Near Redan
Flint Chimney Sweep provides Chimney Repair throughout the I-20 east corridor and beyond. If you live in Stone Mountain, Clarkston, Conyers, or Snellville, you get the same written quote, the same 365-Day Done Right Promise, and the same uniformed technician. Our crews are already running routes through Redan every week, so dispatch times to the surrounding cities stay tight.
Serving Redan, GA - Our Local Coverage Area
We’re based in the Redan area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Chimney Repair in Redan
Yes, and the reason in Redan has less to do with how often you burn and more to do with the climate and the wildlife. Even a chimney that sees two fires a year is still an open chase up the side of your house. In Redan’s humid season, animals nest in unused flues and mortar absorbs moisture year-round regardless of whether there’s ever been a fire in the box. A Level 1 inspection runs $99 to $149 and tells you whether the flue is still sound or whether you’ve been quietly accumulating water damage. Call (830) 251-4560 to schedule one. The inspection fee is credited toward any repair we quote from it.
First-degree creosote is a dry, dusty soot that brushes off easily. Second-degree is the flaky, shiny tar that builds up when flue temperatures fluctuate, and third-degree is the hard, glazed coating that forms when creosote goes through repeated hot and cool cycles. It does change your quote, because the removal method is different. A standard sweep in Redan that recovers first-degree creosote runs $189 to $229. Second-degree takes chemical treatment and longer brush time, pushing the sweep into the $250 to $289 range. Third-degree usually requires professional chemical products that break the glaze down over days, not hours. We’ll show you the creosote on camera before we quote, so you’re not taking anyone’s word for it. Call (830) 251-4560 to get a camera inspector out to your Redan home.
You can repair most factory-built fireplaces, and in Redan that’s what we do most often. The unit itself doesn’t usually need replacing. What fails is the component around it: the chase cover, the cap, the flue liner joint, or the refractory panels inside the firebox. Those are all replaceable parts, and we install manufacturer-specific caps and liners from the same brand families that built the original unit. If your unit’s flue liner has separated at a joint, a DuraFlex relining often solves it without pulling the chase apart. You’d only look at a full replacement if the firebox itself is warped or the manufacturer has issued a recall. We’ll tell you which it is after the camera goes down, and we’ll show you the photos. Call (830) 251-4560 for a written assessment.
Some things in Redan can wait and some cannot. A hairline crack in your crown can usually wait one burning season if you haven’t seen water inside and we don’t see moisture damage in the flue camera. A rusted damper that still opens and closes can also wait. But a failed cap, a cracked flue liner, or a chase cover that’s letting water onto a factory-built unit’s flue should be addressed before the next wet season in Redan, because the damage compounds every time it rains. We won’t push you to spend money the house doesn’t need. Our quotes are written, and if a repair can safely wait, we’ll put that in writing too. Call (830) 251-4560 and we’ll tell you straight.
We give every Redan customer a written, flat price before booking, and there’s no charge for the estimate. When a technician arrives, they’ll run a camera inspection, show you the photos on the spot, and quote the repair exactly as scoped. The number on the quote is the number you approve, and the number on the invoice matches it. Our Redan pricing guidance: chimney caps $285 to $650 for stainless, mortar repointing $400 to $1,200, crown repair $350 to $800, partial rebuilds from $1,800. Every repair carries the 365-Day Done Right Promise in writing. Call (830) 251-4560 and a live person will take your call, day or night.
Contact Flint Chimney Sweep for Chimney Repair in Redan
If you live in Redan and you’re dealing with a leaky chimney, spalling brick, or a fireplace that smokes back into the room, call Flint Chimney Sweep at (830) 251-4560 for a free camera inspection and a written quote. A live person answers around the clock. You’ll get a uniformed, background-checked technician, a documented scope of work, and a one-year written guarantee on every repair we do. No pressure, no doctored photos, no number that changes at the door.
Written by Hank Delano, Owner at Flint Chimney Sweep, serving Redan since 2002.